Put up a little strip below and to the right of the highest window. It was cold, so we went to Lowe's at sundown and tested out materials for our walls and ceiling.
Tuesday, March 14, 2017
March 14, 2017 at 09:42PM
Monday night when I got home from work, my wife was continuing on the ceiling insulation we started over the cold weekend.
Friday, March 10, 2017
March 10, 2017 at 11:11PM
That sheet above three windows and around one... Pretty hard and complicated. But it is up! Meanwhile, I should post a picture of my wife doing load calcs for the HVAC and figuring out the water heater with the best TCO...
Wednesday, March 8, 2017
March 08, 2017 at 07:24AM
Another sheet up. Again, did this in couple steps with a test fit to mark the angle. (And then fit again, when my wife was there to hold it, to make sure it was right before I cut it). It was much less windy last night. And I'm really glad I didn't cut the notch at the end of the day Monday-- I had it marked out to cut the wrong way!
Monday, March 6, 2017
March 06, 2017 at 06:38PM
Cut the notch, tacked it up, marked the angle, and took it down and cut it. Then I put it up again. And then took it down and removed some screws that were in the way. And then put it up and put in all the screws.
Saturday, March 4, 2017
March 04, 2017 at 09:29PM
I did a complex detail for the water faucets that will come through the metal. And finished the sloping wall.
Friday, March 3, 2017
March 03, 2017 at 06:15PM
Started the metal on a new side. Has to fix the trim at the transition at the bottom, partly because we used the wrong sheets on a different side. But it ended up with a better detail.
Subscribe to:
Posts (Atom)