September 30, 2017 at 10:59PM

Working in the sloped end under the loft. ☺

September 23, 2017 at 10:44PM

Beth has been filling the screw holes on the wheel well, and the ceiling. When she is done it's almost invisible.

September 22, 2017 at 06:59PM

1wheel well done!

September 22, 2017 at 05:19PM

Working on the wheel well. Got the vertical cover on, next is the ends and top.

September 19, 2017 at 10:42PM

One more sheet of wallboard to complete the main house.

September 19, 2017 at 10:40PM

Beth is arranging tile for the mud room and hearth. We also got tile for the bathroom.

September 18, 2017 at 06:38PM

I made a three dimensional square.

September 18, 2017 at 06:36PM

Last ceiling panel.

September 17, 2017 at 07:52PM

Last sheet in the loft!

September 16, 2017 at 09:02AM

We keep a shop vac nearby so our workspace stays clean.

September 16, 2017 at 08:59AM

I have achieved enlightenment, or whatever you call it when your stomach is full.

September 15, 2017 at 10:13PM

Some of the wallboard cuts are pretty complex. Here is one around a place where the pipes transition from being in the wall, to running through the "chase".

September 15, 2017 at 10:10PM

The wall board is going up. Sheet after sheet, another sheet, another sheet...

September 15, 2017 at 09:59PM

Cutting out the windows with a router and a flush-cut bit.

September 07, 2017 at 09:53PM

Putting up the first of four sheets of bead-board (or "car-siding"). The lofts get plywood, but the living room gets bead-board.

September 05, 2017 at 09:29PM

Putting up panels on the ceiling. 3/8" BC sanded plywood. I added counter-sinks where I was going to put the screws, and did a round-over with a router on the matched edges. I touched up the sanding with a belt sander. This was the third ceiling sheet, and it fit perfectly the first time.

September 04, 2017 at 05:14PM

I gnawed a hole in the floor to put a gas line through. I drilled a lot of holes real close together, and then drilled them bigger. Thanks, Rusty, for lending me the drill!

September 02, 2017 at 06:01PM

My wife found this cheap little cutter, and we've used one for the rubber roof, and this one made quick work of the re-reused billboard tarp -- trimming the excess.

September 02, 2017 at 05:52PM

Finished the bathroom, and put up a tarp on the ceiling as a vapor barrier. We had gotten this tarp a long time ago, to cover up our house while it was being built, and now I'm able to reuse it as a vapor barrier.