September 15, 2017 at 10:10PM

The wall board is going up. Sheet after sheet, another sheet, another sheet...

September 15, 2017 at 09:59PM

Cutting out the windows with a router and a flush-cut bit.

September 07, 2017 at 09:53PM

Putting up the first of four sheets of bead-board (or "car-siding"). The lofts get plywood, but the living room gets bead-board.

September 05, 2017 at 09:29PM

Putting up panels on the ceiling. 3/8" BC sanded plywood. I added counter-sinks where I was going to put the screws, and did a round-over with a router on the matched edges. I touched up the sanding with a belt sander. This was the third ceiling sheet, and it fit perfectly the first time.

September 04, 2017 at 05:14PM

I gnawed a hole in the floor to put a gas line through. I drilled a lot of holes real close together, and then drilled them bigger. Thanks, Rusty, for lending me the drill!

September 02, 2017 at 06:01PM

My wife found this cheap little cutter, and we've used one for the rubber roof, and this one made quick work of the re-reused billboard tarp -- trimming the excess.

September 02, 2017 at 05:52PM

Finished the bathroom, and put up a tarp on the ceiling as a vapor barrier. We had gotten this tarp a long time ago, to cover up our house while it was being built, and now I'm able to reuse it as a vapor barrier.